The benefits of having a pool at home are endless. But it also comes with a huge responsibility to keep it clean all the time.

Having your very own pool brings joy to the whole family. You can always invite family and friends over to bond and children will have more reasons to stay at home. Not to mention the health benefits it could give to the whole family, such as enhancing the immunity, getting better sleep and more.

Though there’s a long list of benefits of owning a pool at home; once people heard the responsibility they have to take for the maintenance, and cost, they tend to change their mind.

People have different suggestions on the recommended times to clean the pool. But the ideal way to determine it is when one or more of the following occur in your pool:

  • Water starts to turn green or smells bad
  • pH and chlorine levelare not on the right levels. For chlorine, it should not drop below 1.0 parts per million; while the pH level should always be between 7.2 and 7.6.

When it comes to cost, it will only be expensive when you hire a professional cleaner. But it doesn’t have to be that way because you can do it yourself! All you have to do is familiarize yourself with the methods. One of the methods is vacuuming. Vacuuming is essential as it effectively removes dirt and other residues from the water.

But before you do that, make sure to have the following tools: vacuum head, vacuum hose, telescopic pole, pool skimmer and vacuum plate. Once you have every tool on-hand, you can start the vacuuming process.


Here is the simple step-by-step guide on how to vacuum a pool:

STEP 1: Assemble the tools

Attach properly the vacuum head to the telescopic pole then attach one end of the hose to the top of the vacuum head.

STEP 2: Place the tools in the water

Once the tools are properly attached to one another, you can lower it down carefully in the pool until it reaches the floor.

STEP 3: Hose to the skimmer

When the tools are set on the pool’s floor and the air has been 100% removed from the hose, you can insert the other end of the hose to the suction hole of the skimmer and plug it into the vacuum port. Turn the vacuum head ON and the suction will begin.


The first time is usually the most stressful. So, here are some simple ways on how you can detect problems when vacuuming the pool for the first time:

1 Vacuum leak

Bubbles starting to form or the water splashes under the pump lid, or the vacuum just doesn’t suck water – when this problem occurs, a vacuum leak is one of the possible causes.

The first thing to check is the hose connecting to the vacuum head, make sure it is properly attached. If it’s secure properly, find the origin of the leak and seal it up.

2 Burning the pool pump

Failing to remove all the air from the hose before connecting it to the pump can lead to burning the pool pump. If this happens, seek professional help for the repair of the pump.

3 Rushing the vacuum process

Rushing the vacuum process will do more harm than good in your pool. If this done, you’ll just end up re-doing the whole process again.

The best way to do it is by slow and steady, exactly how you vacuum carpets. This will ensure that all residues from every part of the pool will be removed properly.

4 No holes and leaks but still, it doesn’t work

If everything is well-sealed and in good condition but still, it’s not functioning properly; check the pump’s motor. If you’re not mechanically-skilled or doesn’t have the manual on-hand, it’s advisable to seek help from the professional. But if you are, you can troubleshoot it yourself with ease.

DIY pool cleaning may sound tedious. But if you’re equipped with the right tools and knowledge, it can turn into a fun chore. You can find more the choice of Pool Cleaners here